Buy plunger pump Raiders: the most complete plunger pump maintenance specifications

[Asia Pump Network hearing] piston pump repair specifications, including what? Know the plunger pump maintenance specifications, when it fails, you can do it yourself simple maintenance. The following is the plunger pump maintenance specifications for your reference. Plunger pump maintenance specifications (1) check the plunger without scars and rust phenomenon, if necessary, should be replaced with new products. (2) check the plunger with the situation. Insert the end of the plunger into the plunger sleeve with a tilt of about 60 °. If the plunger slides slowly to fit well with itself. (3) Check the sealing of the plunger pair. Hold the plunger sleeve with both hands and block the inlet on the top and side of the plunger with two fingers. With the other hand pulled out of the plunger, feel a greater suction, relax the plunger immediately retracted, indicating good seal of the plunger, or should replace the plunger pair. (4) Check whether the pressure relief valve ring decompression ring has a step or scars, if necessary, should be replaced. (5) Check out the cooperation with the fuel valve. With your fingers plug the hole under the valve, with another finger gently press down the valve, when the finger left the valve out of the top, it can automatically bounce back to the original position, indicating that the valve seal is good, or Should replace the oil valve. (6) Check the tappet body. The standard gap between the pump body and tappet body is 0 ~ 0.03mm, if more than 0.2mm, the parts should be replaced. (7) Check the clearance between the flange of the plunger and the groove of the control sleeve. It should be 0.02 ~ 0.08mm. If it exceeds 0.12mm, the control sleeve must be replaced. Further reading: Pump and Valve Tube & Pipe Fittings Exhibition Information 2016 Exhibition Information Industrial Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: Li Juan (QQ / WeChat :) (Service Hotline:)