Pipeline pump Buying Raiders: Pipeline pump motor burned what causes

Some pump users in the pipeline for some time and found that there will be pipe pump motor burned situation occurs, then the pipe pump motor burned what is the reason, but also how to troubleshoot this issue Xiaobian from the pipeline Analysis of the reasons for the burning of the pump and solutions to start with, for your interpretation of the use of pipeline pump Raiders. Where to buy high-quality pipe pump 1, submersible pump before demolition, should be in the end cover and seat sewn at the mark. In order to repair the assembly as it is, it will not cause assembly errors caused by the shaft is not the heart; in the removal of the submersible pump impeller and bushings and other components, it should be noted that must not hard hit hard impulse, available thermal expansion principle, heating edge Tap or use "Rama" and other tools to remove. Winding burn should be analyzed for reasons (overload, pump, lack of phase, leakage leakage short circuit, etc.), remove the motor windings, do not make the silicon steel tilt shift and burr and other phenomena, so as not to knock in the new winch assembly "bell mouth "Cause ground or short circuit fault. Rewound the new coil, the enameled wire and insulating paper must be selected regular manufacturers, due to submersible pump motor heat level is generally e, b level. Must pay attention to its level of heat corresponding. Low insulation thickness should be sufficient, and to pad inserted in place. Winding off the assembly line, be careful not to scratch the stator core coil, but also avoid using crossed repeatedly crossed. 2, check wearing parts: submersible pump impeller, buckle, sleeve, bearing seat, etc. are wearing parts. First of all the pump should be removed, check the wearing parts are intact. Do not use damaged or unqualified parts. 3, replace the oil: respectively, open the seal chamber and the motor inside the hole screw, the sealed chamber and the motor internal lubricant all released, replace the new oil, to ensure the normal lubrication system work. 4, to ensure bearing lubrication: water-filled submersible pump should check the replacement of the upper and lower end of the bearing housing skeleton oil seal and lithium-based grease. To ensure long-term bearing lubrication in good condition. 5, the demolition of the pump casing rust: Spring before use, should be disassembled the pump casing, turn the impeller and then start closing, to prevent rusting parts can not start normally and burn the motor. This maintenance is especially important for water filled motors. 6, to ensure that the seal: agricultural submersible pumps on the sealing requirements are very strict, in the replacement of sealed chamber oil, if you find the oil cloudy and moisture content, you must replace or replace the seal box or seal the entire ring to ensure that the seal Good performance. Further reading: Pump and Valve Tube Fittings Exhibition Information 2016 Exhibition Information Industrial Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: Fenfen (QQ / Wechat:) (Service Hotline:)